Compressor And Magnetic Clutch: Installation

INSTALL COOLER COMPRESSOR ASSEMBLY
1. Install the cooler compressor with the 4 bolts.
  Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
  
  NOTE: Tighten the bolts in the order shown in the illustration to install the cooler compressor.
2. Connect the connector.
  
  Fig 1: Identifying Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
1. Remove the attached vinyl tape from the hose.
2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
  Compressor oil:
  
  ND-OIL 8 or equivalent
3. Install the O-ring on the cooler refrigerant discharge hose.
4. Install the cooler refrigerant discharge hose on the cooler compressor with the bolt.
  Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Identifying O-Ring On Cooler Refrigerant Discharge Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE
1. Remove the attached vinyl tape from the hose.
2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
  Compressor oil:
  
  ND-OIL 8 or equivalent
3. Install the O-ring on the cooler refrigerant suction hose.
4. Install the cooler refrigerant suction hose on the cooler compressor with the bolt.
  Torque: 9.8 N*m (100 kgf*cm, 7 ft.*lbf)
  
  Fig 3: Identifying Cooler Refrigerant Suction Hose Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FAN AND GENERATOR V BELT (See REMOVAL )
INSTALL ENGINE UNDER COVER RH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHARGE REFRIGERANT (See REPLACEMENT )
WARM UP ENGINE (See REPLACEMENT )
INSPECT FOR REFRIGERANT LEAK (See REPLACEMENT )