Water Pump: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
DRAIN ENGINE COOLANT (See COOLANT )
REMOVE FRONT FENDER APRON SEAL RH (See REMOVAL )
REMOVE ENGINE UNDER COVER RH
REMOVE FAN AND GENERATOR V BELT (See REMOVAL )
REMOVE GENERATOR ASSEMBLY (See REMOVAL )
REMOVE WATER PUMP PULLEY
1. Using SST, remove the 4 bolts and water pump pulley.
  SST 09960-10010 (09962-01000, 09963-00700)
  
  Fig 1: Removing Water Pump Pulley
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE WATER PUMP ASSEMBLY
1. Remove the clamp of the crankshaft position sensor from the water pump.
2. Disconnect the wire of the crankshaft position sensor from the clamp bracket.
  
  Fig 2: Locating Crankshaft Position Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 4 bolts, 2 nuts and clamp bracket.
  
  Fig 3: Locating Clamp Bracket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
  NOTE: Be careful not to damage the contact surface of the water pump and cylinder block.
  
  Fig 4: Prying Between Water Pump And Cylinder Block
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002