Front Bumper: Removal

1. Remove the 3 screws.
2. Partially remove the fender liner.

   HINT:

   It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.

Fig 1: Identifying Front Fender Liner And Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures described for the LH side.

1. Remove the 3 screws and 2 bolts.
2. Using a clip remover, remove the clip labeled A, 2 clips labeled B, and 2 radiator protectors.
   Fig 2: Identifying Clips And 2 Radiator Protectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Apply protective tape under the front fender.
4. Using a screwdriver, detach the 6 claws labeled A and 2 claws labeled B, and remove the bumper cover.

   HINT:

   Tape the screwdriver tip before use.

   Fig 3: Applying Protective Tape Under Front Fender

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 6 nuts and reinforcement.
   Fig 4: Identifying Nuts And Reinforcement

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the screw and bolt.
2. Using a screwdriver, detach the 2 clips, and remove the side support.

   HINT:

   Tape the screwdriver tip before use.

Fig 5: Identifying Clips And Side Support
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures described for the LH side.