Data List / Active Test

HINT:

Using the intelligent tester DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST according to the display on the tester.

   Skid control ECU with actuator 

   DATA LIST - SKID CONTROL ECU WITH ACTUATOR
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   VEHICLE SPD	Wheel speed sensor (FR) reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Actual vehicle speed	Speed indicated on speedometer

   ECM 

   DATA LIST - ECM
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   ENGINE SPD	Engine speed / Min.: 0 rpm, Max.: 16,383 rpm	Idling: 650 to 750 mph	-
   COOLANT TEMP	Coolant temperature / Min.: - 40°C, Max.: 140°C	After warming up: 80 to 95°C (176 to 203°F)	If the value is "-40 or 140°C", sensor circuit is open or short