Data List / Active Test
HINT:
By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST is the first step of troubleshooting and is one method to save time.
- DATA LIST FOR CENTER AIRBAG SENSOR ASSEMBLY
- Connect the intelligent tester (with CAN VIM) to the DLC3.
- Turn the ignition switch ON.
- Following the display on the tester screen, read the "DATA LIST".
Center airbag sensor assembly:
DATA LIST REFERENCE
| Item | Measurement Item/Range (Display) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D SEAT POSITION | Seat position (Driver side)/FORWARD: Seat is in position that is toward front BKWARD: Seat is in position that is toward rear FAIL: Failure detected |
FORWARD/BKWARD | - |
| PASSENGER DETEC | Passenger detection/NG: Data is not determined NONE: No passenger DETECT: Passenger exists FAIL: Failure detected |
NONE/DETECT | - |
| L BUCKLE SW | Buckle switch (Left side)/UNSET: Seat belt is not fastened SET: Seat belt is fastened NG: Data is not determined |
UNSET/SET | - |
| R BUCKLE SW | Buckle switch (Right side)/UNSET: Seat belt is not fastened SET: Seat belt is fastened NG: Data is not determined |
UNSET/SET | - |
| DISPLAY TYPE | Display type identification information/LR: Display is indicated by LH/RH DP: Display is indicated by Driver/Passenger |
LR | - |
| PAST CODES | Number of past trouble codes/Min.: 0, Max.: 255 | 0 | - |