Data List / Active Test

HINT:

Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

1. Connect the intelligent tester (with CAN VIM) to the DLC3.
2. Turn the ignition switch ON.
3. Read the DATA LIST according to the display on the tester.

   Skid control ECU with actuator 

   SKID CONTROL ECU WITH ACTUATOR REFERENCE
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   WHEEL SPD FR	Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost equal to speedometer value (when driving)	-
   WHEEL SPD FL	Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost equal to speedometer value (when driving)	-
   WHEEL SPD RR	Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)	Almost equal to speedometer value (when driving)	-
   WHEEL SPD RL	Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326km/h (202 mph)	Almost equal to speedometer value (when driving)	-

   ECM 

   ECM REFERENCE
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   ENGINE SPD	Engine speed: Min.: 0, Max.: 16,383 rpm	600 to 700 rpm: Idling (M/T) 650 to 750 rpm: Idling (A/T)	-
   COOLANT TEMP	Engine coolant temperature (ECT): Min.: -40°C (-40°F), Max.: 140°C (284°F)	75 to 100°C (167 to 203°F): After warming up engine	If value -40°C (-40°F): ECT sensor open If value 140°C (284°F) or higher: ECT sensor shorted