LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2006 >> tC Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Front Passenger Airbag Assembly >> Removal

Front Passenger Airbag Assembly: Removal

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see AIRBAG SYSTEM  ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 
  3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Disconnect the connector from the airbag.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
    2. Remove the instrument panel sub-assembly upper (see REMOVAL ).
    3. Remove the clip.
      Fig 1: Disconnect Connector From Airbag
      G04223957Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the connectors and remove the instrument panel wire assembly.
    5. Remove the 2 screws.
      Fig 2: Disconnect Connectors And Removing Instrument Panel Wire Assembly
      G04223958Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Release the front side airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly rearward.
    7. Release the rear side airbag door from the other hook and remove the front passenger airbag assembly.
    Fig 3: Removing Front Side Airbag Door From Hook
    G04223959Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals