How To Proceed With Troubleshooting

HINT:

The hand-held tester can be used in steps  3,  6,  9, and  12.

1. Vehicle Brought to Workshop 
   1. NEXT 
2. (See  CUSTOMER PROBLEM ANALYSIS CHECK   ) 
   1. NEXT 
3. Check and Clear DTCs and Freeze Frame Data (See  DTC CHECK/CLEAR   ) 
   1. NEXT 
4. Problem Symptom Confirmation (See  PROBLEM SYMPTOMS TABLE   ) 

   Result: 

   SYMPTOMS RESULT
   
   

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   1. B : Go to step   6 
   2. A : GO TO NEXT STEP. 
5. Symptom Simulation (See  PROBLEM SYMPTOMS TABLE   ) 
   1. NEXT 
6. (See  DTC CHECK/CLEAR   ) 

   Result: 

   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   1. B : Go to step   8 
   2. A : GO TO NEXT STEP. 
7. PROBLEM SYMPTOMS TABLE   ) 
   1. NEXT: Check for fluid leakage and Go to step   10 
8. DTC Table (See  DIAGNOSTIC TROUBLE CODE TABLE   ) 
   1. NEXT 
9. Circuit Inspection (See  DTC C0200/31, C0205/32, C1235/35, C1236/36: RIGHT FRONT SPEED SENSOR SIGNAL MALFUNCTION, LEFT FRONT SPEED SENSOR SIGNAL MALFUNCTION, FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR   to  TS TERMINAL CIRCUIT  ) 
   1. NEXT 
10. Identification of Problem 
    1. NEXT 
11. Repair 
    1. NEXT 
12. Confirmation Test 
    1. NEXT : End