LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2005 >> xA Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Abs With EBD & BA & TRAC & VSC System >> DTC C1210/36, C1336/39: Zero Point Calibration Of Yaw Rate Sensor Undone, Zero Point Calibration Of Deceleration Sensor Undone >> Circuit Description

Circuit Description

The deceleration sensor is built into the yaw rate sensor.

DTC CONDITION DETECTION

DTC No. DTC Detection Condition Trouble Area
C1210/36
  1. After ECU was replaced, the shift lever was moved to position other than P within 15 sec. immediately after ECU terminal IG1 turns ON for the first time.
  2. Yaw rate sensor zero point recorded in ECU is deleted.
  • Yaw rate sensor
  • Yaw rate sensor circuit
  • Zero point calibration not done
C1336/39 At initial time after replacing the ECU, or after erasing deceleration sensor memory by connecting terminals TS and CG of the DLC3, the ignition switch is turned ON and the vehicle is driven in any mode except for the test mode.
  • Yaw rate sensor (Deceleration sensor)
  • Yaw rate sensor circuit (Deceleration sensor)
  • Zero point calibration not done
scientia non olet · About LEMON Manuals