LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2004 >> xB Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Abs With EBD & BA & TRAC & VSC System - Diagnosis >> DTC C1210/36, C1336/39: Zero Point Calibration Of Yaw Rate Sensor Undone, Zero Point Calibration Of Deceleration Sensor Undone >> Circuit Description

Circuit Description

Deceleration sensor is included in yaw rate sensor.

DTC C1210/36, C1336/39 REFERENCE

DTC No. DTC Detecting Condition Trouble Area
C1210/36
  1. After ECU was replaced, when the shift lever was moved other than to P position within 15 sec. soon after ECU terminal IG1 become ON for the first time.
  2. When the yaw rate sensor zero point recorded in ECU is deleted.
  • Yaw rate sensor
  • Yaw rate sensor circuit
  • Zero point calibration not done
C1336/39 At the initial time after replacing the computer, or after erasing the deceleration sensor memory by operating the terminals Ts and CG of DLC3, the ignition is turned ON and the vehicle is driven in any mode except for the test mode.
  • Yaw rate sensor (Deceleration sensor)
  • Yaw rate sensor circuit (Deceleration sensor)
  • Zero point calibration not done
scientia non olet · About LEMON Manuals