Removal and Installation for Audio Unit

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Perform damper lock operation. Refer to "Locking CD auto-changer mechanism (Audio unit of BOSE system) ".
Remove cluster lid C. Refer to CLUSTER LID C .
Unlock FPM (Flexible Print Circuit) connector lock on A/C and audio controller side.
Pull off flexible printed circuit from connector.

Fig 1: Pulling Off Flexible Printed Circuit From Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove screws (top: 2).

Fig 2: Removing Screws
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove screws (bottom: 4). Remove audio unit and display unit assembly (with navigation system) from cluster lid C.

Fig 3: Removing Audio Unit And Display Unit Assembly (With Navigation System) From Cluster Lid C
Courtesy of NISSAN MOTOR CO., U.S.A.
Separate audio unit from display unit assembly (with navigation system).

Fig 4: Separating Audio Unit From Display Unit Assembly (With Navigation System)
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove 8 screws, and then bracket.
CAUTION:
- When carrying audio unit body, do not touch internal mechanism access from cassette tape slot.
- Be careful not to allow foreign material to enter from cassette tape slot.
- Removal and Installation of A/C and Audio Controller.
  
  Fig 5: Removing Bracket
  Courtesy of NISSAN MOTOR CO., U.S.A.