Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure sequence.

Assemble the following three parts carefully.

Console Finisher (A/T Models)

Put selector lever to driving position.
Put indicator panel to front side.
Connect each harness connectors.

Fig 1: Console Finisher (A/T Models)
Courtesy of NISSAN MOTOR CO., U.S.A.
While pushing forward and holding A/T indicator panel, engage metal clip at front of console finisher. Then insert guide pin into A/T device guide.
CAUTION: Guide pin at back of console finisher can be easily broken. Be careful not to break it when working.

Fig 2: Installing Console Finisher (A/T Models)
Courtesy of NISSAN MOTOR CO., U.S.A.

Console Boot (M/T Models)

Bring console boot to front side and connect front section metal clip.
After confirming secure connection of front section metal clip, connect rear section metal clip.

NOTE: Insert securely to make sure there is on clearance of seam between lower section of cluster lid C and front section of center console.

Steering Column Shaft

When securing steering column shaft with bolts, position it so that both left and right gaps between instrument panel and steering column shaft become identical.

Fig 3: Installing Steering Column Shaft

Courtesy of NISSAN MOTOR CO., U.S.A.

Instrument Lower Driver Panel

Inserting lower left clip is rather difficult. After installation ensure that clip is correctly inserted.

Fig 4: Installing Instrument Lower Driver Panel

Courtesy of NISSAN MOTOR CO., U.S.A.