LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Controls And Fuel - 2.4L - DTC P0010 To DTC P0366) >> DTC P0335 or P0336 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
NOTE: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Remove the crankshaft position sensor and inspect the sensor and the O-ring for damage.
  2. Connect the connector to the crankshaft position sensor.
  3. Ignition ON, engine OFF, observe the Crankshaft Position Active Counter while passing a steel object by the tip of the sensor repeatedly. The Crankshaft Position Active Counter should increment.
    • If the Crankshaft Position Active Counter does not increment, replace the crankshaft position sensor.
scientia non olet · About LEMON Manuals