Conditions for Running the DTC: P0140
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The ECT Sensor parameter is more than 70°C (158°F).
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Engine Run Time parameter is more than 200 seconds.
- The Loop Status parameter is closed.
- DTC P0140 runs once per drive cycle when the above conditions are met.