P0137 Power Enrichment Test Enable
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The Loop Status parameter is Closed.
- The Ignition 1 Signal parameter is between 10-18 volts.
- The Fuel Level Sensor parameter is more than 10 percent.
- The Engine Run Time parameter is more than 30 seconds.
- The Power Enrichment parameter is active for more than 2 seconds.
- DTC P0137 runs the power enrichment test during each occurrence of power enrichment, when the above conditions are met for 3 seconds.