P0141 Heater Current Test
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
- The ECT Sensor parameter is more than 70°C (158°F).
- The Ignition 1 Signal parameter is between 10-18 volts.
- The MAF Sensor parameter is between 5-25 g/s.
- The Engine Run Time parameter is more than 60 seconds.
- The Engine Speed parameter is between 500-3,000 RPM.
- DTC P0141 runs the heater current test twice per drive cycle when the above conditions are met for 2 seconds.