LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls And Fuel - 2.4L - Troubleshooting And Diagnosis) >> Fuel Pump Electrical Circuit Diagnosis >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the fuel pump relay using the J 43244:  Pliers.
  2. Ignition ON, verify that a test lamp illuminates between the ground circuit terminal 85 and B+.
    • If the test lamp does not illuminate, test the ground circuit for a short to voltage or an open/high resistance.
  3. Verify that a test lamp does not illuminate between the ground circuit terminal 85 and the control circuit terminal 86.
    • If the test lamp illuminates, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. Remove the test lamp.
  5. Command the fuel pump relay ON with a scan tool. Verify the scan tool Fuel Pump Relay Ckt Short Gnd Test Status parameter is OK.
    • If not the specified value, test the fuel pump relay control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  6. Install a 3 A fused jumper wire between the fuel pump relay control circuit terminal 86 and the ground circuit terminal 85. Command the fuel pump relay ON with a scan tool. Verify the scan tool Fuel Pump Relay Ckt Short Gnd Test Status parameter is Fault.
    • If not the specified value, test the fuel pump relay control circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  7. Inspect the fuel pump fuse.
    • If the fuel pump fuse is open, test for the following conditions:
      • A short to ground in the relay switch B+ circuit
      • A short to ground in the supply voltage circuit of the fuel pump
    • If the above circuits test normal, replace the fuel pump module.
  8. Verify that a test light illuminates between the B+ circuit terminal 30 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for an open/high resistance.
  9. Connect a 15 A fused jumper wire between the B+ circuit terminal 30 and the supply voltage circuit terminal 87 of the fuel pump. Verify the fuel pump is activated.
    • If the fuel pump does not activate, test for the following conditions:
      • An open/high resistance in the supply voltage circuit of the fuel pump
      • An open/high resistance in the ground circuit of the fuel pump
    • If the above circuits test normal, replace the fuel pump module.
  10. If all circuits test normal, test or replace the fuel pump relay.
scientia non olet · About LEMON Manuals