LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L - Repair Instructions - On Vehicle) >> Valve Stem Oil Seal and Valve Spring Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Prevent the crankshaft from rotating clockwise or counterclockwise before using compressed air in the cylinder. Rotation of the crankshaft may cause damage to EN-43653:  holding tool.
  1. If equipped, with a manual transmission leave the transmission in first gear with the vehicle on the ground and the parking brake set.
  2. If equipped, with an automatic transmission, remove the starter. Refer to Starter Replacement .
  3. Install EN-43653:  holding tool.
  4. Remove the camshaft. Refer to Intake Camshaft and Valve Lifter Replacement  or Exhaust Camshaft and Valve Lifter Replacement .
    5. Fig 1: Identifying Camshaft Roller Followers
    GM2401694Courtesy of GENERAL MOTORS CORP.
  5. Remove the camshaft roller followers (1).
    6. Fig 2: View Of Valve Spring Compressor Adaptor Set
    GM2401706Courtesy of GENERAL MOTORS CORP.
  6. Install the EN-43649-10:  adaptor set (1) to the front and rear of the cylinder head.
  7. Install the cross bars and locks (2) of the EN-43649:  compressor to the valve spring compressor adaptors.
  8. Remove the spark plugs. Refer to Spark Plug Replacement .
  9. Install an air hose adapter into the spark plug hole.
  10. Attach an air hose to the adapter and pressurize the cylinder to 690 kPa (100 psi).
  11. Compress the valve spring using the valve spring compressor (3).
    12. Fig 3: View Of Valve Spring, Keepers & Retainer
    GM2401713Courtesy of GENERAL MOTORS CORP.
  12. Remove the valve spring keepers (1).
  13. Remove the valve spring (3) and retainer (2).
    14. Fig 4: View Of Valve Guide Seal Remover/Installer
    GM2401716Courtesy of GENERAL MOTORS CORP.
  14. Use the EN-36017:  seal remover (1) to remove the valve seal.
scientia non olet · About LEMON Manuals