LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L - Repair Instructions - On Vehicle) >> Valve Stem Oil Seal and Valve Spring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Valve Guide Seal Remover/Installer
    GM2401716Courtesy of GENERAL MOTORS CORP.
  1. Using the EN-36017:  seal remover (1) install the NEW valve seal. Fully seat the seal onto the valve guide.
    2. Fig 2: View Of Valve Spring, Keepers & Retainer
    GM2401713Courtesy of GENERAL MOTORS CORP.
  2. Install the valve spring (3) and retainer (2).
  3. Compress the valve spring using the valve spring compressor.
  4. Install the valve spring keepers (1).
  5. Disconnect the air hose and air hose adapter.
    6. Fig 3: View Of J 43649 Valve Spring Compressor (Cylinder Head)
    GM1675271Courtesy of GENERAL MOTORS CORP.
  6. Remove the EN-43649:  compressor and EN-43649-10:  adaptor set from the cylinder head.
  7. Install the spark plugs. Refer to Spark Plug Replacement .
    8. Fig 4: Identifying Camshaft Roller Followers
    GM758358Courtesy of GENERAL MOTORS CORP.
  8. Install the camshaft roller followers.
  9. Install the camshaft. Refer to Intake Camshaft and Valve Lifter Replacement  or Exhaust Camshaft and Valve Lifter Replacement .
  10. If used, remove the EN-43653:  holding tool.
  11. If removed, install the starter. Refer to Starter Replacement .
scientia non olet · About LEMON Manuals