LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L - Repair Instructions - On Vehicle) >> Engine Mount Bracket Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Harness Tie Straps & Cable Clips
    GM1592511Courtesy of GENERAL MOTORS CORP.
  1. Remove the left engine mount. Refer to Engine Mount Replacement - Left Side .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the starter solenoid positive battery cable nut (4) from the starter.
  4. Remove the positive battery cable terminal (5) from the starter.
    5. Fig 2: Identifying Engine Harness Electrical Connectors
    GM1590505Courtesy of GENERAL MOTORS CORP.
  5. Reposition the positive battery cable boot (4).
  6. Remove the generator positive battery cable nut (2) from the generator.
  7. Remove the positive battery cable terminal (5) from the generator.
    8. Fig 3: Identifying Intake Manifold Engine Harness Clip
    GM1590535Courtesy of GENERAL MOTORS CORP.
  8. Remove the engine harness clip (4) from the intake manifold.
    9. Fig 4: View Of Engine Mount Bracket & Bolts
    GM1592520Courtesy of GENERAL MOTORS CORP.
  9. Remove the left side engine mount bracket bolts and bracket.
scientia non olet · About LEMON Manuals