LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.4L - Repair Instructions - On Vehicle) >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transmission, if equipped. Refer to Transmission Replacement .
  2. Remove the clutch, if equipped. Refer to Clutch Pressure and Driven Plate Replacement .
  3. Using the J 38122-A  , hold the crankshaft balancer.
    4. Fig 2: View Of Flywheel (Automatic Transaxle)
    GM1578311Courtesy of GENERAL MOTORS CORP.
    NOTE: It may be necessary to remove the chamfer (bevel) from the edge of an 18 mm socket in order to get full engagement on the thin-headed flywheel bolts.
  4. Remove the flywheel bolts, if equipped with a automatic transmission.
    5. NOTE: Do not orientate the flywheel to the crankshaft. It is balanced separately from the engine.
  5. Remove the flywheel.
  6. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
    7. Fig 3: View Of Flywheel & Bolt (Manual Transmission)
    GM1591936Courtesy of GENERAL MOTORS CORP.
  7. Remove the flywheel bolts, if equipped with a manual transmission.
  8. Remove the flywheel.
  9. Clean the thread adhesive from the flywheel bolt holes. Use a nylon bristle brush to clean the holes in the crankshaft.
scientia non olet · About LEMON Manuals