LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (2 Of 2)) >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Oil Level Indicator & Tube
    GM1867002Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the oil level indicator tube O-ring. Refer to Adhesives, Fluids, Lubricants, and Sealers .
  2. Install the oil level indicator and the oil level indicator tube into the oil pan.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil level indicator tube bracket to the intake manifold bolt and tighten to 10 N.m (89 lb in).
  4. Install the electrical wiring harness to the oil level indicator tube.
  5. Install the knock sensor wiring clip into the oil level indicator tube.
scientia non olet · About LEMON Manuals