LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (2 Of 2)) >> Exhaust Manifold Installation

Exhaust Manifold Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Exhaust Manifold Studs
    GM412550Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install new exhaust manifold studs and tighten to 10 N.m (89 lb in).
    2. Fig 2: View Of Exhaust Manifold, Gasket & Retaining Nuts
    GM1594325Courtesy of GENERAL MOTORS CORP.
  2. Install the exhaust manifold gasket.
  3. Install the exhaust manifold to the cylinder head.
  4. Install NEW exhaust manifold to cylinder head retaining nuts finger tight.
    5. Fig 3: Identifying Exhaust Manifold Bolt Tightening Sequence
    GM1340643Courtesy of GENERAL MOTORS CORP.
  5. Tighten the NEW exhaust manifold to cylinder head retaining nuts in sequence. Tighten the nuts a second time to 14 N.m (124 lb in).
    6. Fig 4: View Of Oxygen Sensor
    GM1594322Courtesy of GENERAL MOTORS CORP.
  6. Coat the threads of the oxygen sensor with antiseize P/N 12397953 or equivalent.
  7. Install the oxygen sensor and tighten to 42 N.m (31 lb ft).
    8. Fig 5: View Of Exhaust Manifold Heat Shield & Bolts
    GM1594316Courtesy of GENERAL MOTORS CORP.
  8. Install the exhaust manifold heat shield.
  9. Install the exhaust manifold heat shield bolts and tighten to 22 N.m (16 lb ft).
scientia non olet · About LEMON Manuals