Transmission Final Test and Inspection
WARNING: This page is about a different variant/trim than selected.
Complete the following procedure after the transmission is installed in the vehicle:
- With the ignition OFF or disconnected, crank the engine several times. Listen for any unusual noises or evidence that any parts are binding.
- Start the engine and listen for abnormal conditions.
- While the engine continues to idle raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Inspect for fluid leaks while the engine is idling.
- Lower the vehicle.
- Perform a final inspection for the proper fluid level.
- Reset the TAP values. Refer to Transmission Adaptive Functions .
- Road test the vehicle.
NOTE:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM), or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM), or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.