LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Internal Electrical Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Internal Wiring Harness
    GM792825Courtesy of GENERAL MOTORS CORP.
  1. Install new O-ring seals (3) onto the internal wiring harness (2) if the O-rings were previously removed.
  2. Install the internal wiring harness (2) to the transmission.
    3. Fig 2: View Of Internal Wiring Harness & Retainer
    GM812734Courtesy of GENERAL MOTORS CORP.
  3. Install the internal wiring harness retainer (2) to the internal wiring harness (1).
    4. Fig 3: View Of Transmission (Pan Removed)
    GM822499Courtesy of GENERAL MOTORS CORP.
  4. Connect the internal wiring harness to components (1-8).
    5. Fig 4: View Of Transmission Wiring Harness Connector & Locking Latch
    GM785868Courtesy of GENERAL MOTORS CORP.
  5. Connect the transmission wiring harness connector (1) to the transmission by rotating the locking latch (2) clockwise.
  6. Install the Transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    7. IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  7. Reset the TAP values. Refer to Transmission Adaptive Functions .
scientia non olet · About LEMON Manuals