LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Special Tool J 41623-B & Generator Cooling Inlet Pipe
    GM1195053Courtesy of GENERAL MOTORS CORP.
  1. Install the J 41623-B  onto the transmission oil cooler (TOC) pipe.
    2. Fig 2: View Of Sliding Special Tool J 41623-B Toward EOC Pipe Fitting
    GM1195054Courtesy of GENERAL MOTORS CORP.
  2. Slide the J 41623-B  toward the TOC pipe fitting.
    3. Fig 3: View Of Special Tool J 41623-B On Coolant Pipe
    GM1195056Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Rotate the J 41623-B  to engage the TOC pipe fitting's retainer slots.
    The J 41623-B  should be nearly flush with the fitting.
  3. Connect the J 41623-B  onto the TOC pipe fitting.
    4. Fig 4: Identifying Retainer Clip
    GM1195059Courtesy of GENERAL MOTORS CORP.
  4. Rotate the J 41623-B  until the retainer clip (1) rises above the fitting retainer seat.
    5. Fig 5: View Of Special Tool J 41623-B & Generator Cooling Inlet Pipe
    GM1195062Courtesy of GENERAL MOTORS CORP.
  5. Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
  6. Remove the J 41623-B  from the TOC pipe.
scientia non olet · About LEMON Manuals