LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Torque Converter Fluid Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Torque Converter Seal, Bolts & Special Tool J 8092
    GM812733Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 8092  onto J 44766  . See Special Tools .
  2. Install the torque converter seal onto the tool before installing into the case to prevent damage to the seal.
    3. NOTE: Align the torque converter seal with the bolt holes.
  3. Install the torque converter seal into the torque converter housing.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the torque converter seal bolts and tighten to 3.6 N.m (32 lb in).
  5. Install the transmission torque converter. Refer to Torque Converter Replacement .
scientia non olet · About LEMON Manuals