LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Shift Control Linkage Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Shift Control Linkage & Manual Shift Shaft Nut
    GM1612916Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control linkage (2) to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the manual shift shaft nut (1) and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Shift Control Assembly & Linkage
    GM1612912Courtesy of GENERAL MOTORS CORP.
  3. Connect the shift control linkage rod (2) to the shift control assembly (1).
  4. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment .
  5. Install the front closeout panel. Refer to Floor Panel Tunnel Panel Replacement - Front (Automatic Transmission) .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals