LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Pressure Control Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disassembled View Of Pressure Control Solenoid (PCS)
    GM792778Courtesy of GENERAL MOTORS CORP.
  1. Install new O-ring seals (3-4) to the pressure control solenoid (1), if the O-rings were previously removed.
  2. Install the pressure control solenoid (1) into the control valve body.
    3. Fig 2: Locating Solenoid Retainer
    GM795835Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure control solenoid retainer into the control valve body.
    4. Fig 3: View Of PCS & Electrical Wiring Harness Connector
    GM795921Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical wiring harness connector (2) to the pressure control solenoid (1).
  5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    6. IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  6. Reset the TAP values. Refer to Transmission Adaptive Functions .
scientia non olet · About LEMON Manuals