LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 5L40-E/5L50-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Output Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Output Speed Sensor & Bolt
    GM812728Courtesy of GENERAL MOTORS CORP.
  1. Install the output speed sensor spacer (1).
  2. Install the output speed sensor (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the output speed sensor bolt (3).

    Tighten:  Tighten the output speed sensor bolt to 11 N.m (97 lb in).

    4. Fig 2: View Of Output Speed Sensor & Electrical Wiring Harness Connector
    GM795914Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical wiring harness connector (3) to the output speed sensor (2).
  5. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
scientia non olet · About LEMON Manuals