LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (1 Of 2)) >> Oil Pump Assemble

Oil Pump Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Pump Assembly Components
    GM720891Courtesy of GENERAL MOTORS CORP.
  1. Lubricate all oil pump parts with engine oil.
  2. Install the inner gear into the outer gear.
    3. NOTE: If gears are improperly installed in the front cover, the gerotor cover will not bolt on.
  3. Install the gears together into the front cover with the hub of the center gear facing the front cover.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the oil pump gerotor cover and bolts and tighten to 6 N.m (53 lb in).
    5. Fig 2: View Of Pressure Relief Valve
    GM412482Courtesy of GENERAL MOTORS CORP.
  5. Install the pressure relief valve piston.
  6. Install the pressure relief valve spring.
  7. Install and tighten the pressure relief valve plug to 40 N.m (30 lb ft).
scientia non olet · About LEMON Manuals