LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (1 Of 2)) >> Intake and Exhaust Camshaft, Bearing Cap, and Lash Adjuster Removal >> Intake Camshaft Removal

Intake Camshaft Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Camshaft Caps
    GM1403944Courtesy of GENERAL MOTORS CORP.
    NOTE: Remove each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.
  1. Mark camshaft caps to ensure they are installed in the same position.
  2. Remove the intake camshaft cap bolts.
  3. Remove the camshaft caps.
  4. Remove the intake camshaft.
    5. Fig 2: Identifying Camshaft Roller Finger Followers
    GM1403946Courtesy of GENERAL MOTORS CORP.
    NOTE: Keep all of the roller finger followers and hydraulic lash adjusters in order so that they can be reinstalled in their respective locations.
  5. Remove the intake camshaft roller finger followers.
    6. Fig 3: Identifying Hydraulic Lash Adjusters
    GM1404027Courtesy of GENERAL MOTORS CORP.
  6. Remove the hydraulic lash adjusters.
scientia non olet · About LEMON Manuals