LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (1 Of 2)) >> Cylinder Head Installation (LAP, LAT, LE5, LE8, LE9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Cylinder Head & Gasket
    GM2148512Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use any sealing material.
  1. Install the cylinder head gasket (2) to the block.
  2. Install the cylinder head (1).
    3. Fig 2: Identifying Cylinder Head Bolt Tightening Sequence
    GM412510Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: Always use new cylinder head bolts.
  3. Install and tighten the cylinder head bolts in sequence.
    • Tighten the bolts to 30 N.m (22 lb ft) .
    • Using the EN 45059:  meter , tighten the bolts an additional 155 degrees in sequence.
    4. Fig 3: Identifying Front Cylinder Head Bolts
    GM2146376Courtesy of GENERAL MOTORS CORP.
  4. Install the front cylinder head bolts (1) and tighten to 35 N.m (26 lb ft).
scientia non olet · About LEMON Manuals