LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 2.4L - Repair Instructions - Off Vehicle (1 Of 2)) >> Crankshaft Rear Oil Seal Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Crankshaft Rear Oil Seal & Special Tool J 42067
    GM412495Courtesy of GENERAL MOTORS CORP.
  1. Remove excess sealer from seal recess.
  2. Lubricate the outside diameter of the new crankshaft seal with clean engine oil.
  3. Using the EN 42067:  installer, press the new crankshaft seal into the housing. The EN 42067:  installer also establishes the depth of the seal in the crankshaft seal bore.
scientia non olet · About LEMON Manuals