LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2010 >> Sky Red Line, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls And Fuel - 2.4L - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank (Convertible) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Line
    GM1594375Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP line (1) to the fuel tank.
  2. Engage the EVAP vapor line to the fuel tank retaining features.
  3. Remove the caps or plugs from the EVAP line connections, fuel pump module, and canister.
  4. Connect the EVAP line quick connect fitting to the roll over valve. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Connect the EVAP line quick connect fitting at the fuel sender. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the EVAP line quick connect fitting at the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals