Seat Cushion Trim Cover and Pad Replacement

Fig 1: Identifying Seat Cushion Trim Cover & Pad

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Preliminary Procedures Remove the front seat. Refer to Driver or Passenger Seat Replacement . Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Control Module References .
1	Seat Back Recliner Nut CAUTION: Refer to Fastener Caution . Tighten: 22 N.m (16 lb ft)
2	Seat Cushion Cover Retainer (Qty: 4) Tip: Use a J 38778 Door Trim Pad Clip Remover to aid in the removal of the seat cushion cover retainers. Special Tools: J 38778: Door Trim Pad Clip Remover
3	Seat Cushion Cover Tip: Tilt the seat back forward. Disconnect the seat cushion cover J-channel from the front and rear of the seat cushion frame. Disconnect the electrical connector if working on the passenger seat.
4	Seat Cushion Pad Tip: The passenger presence system is part of the pad on the passenger seat cushion, and must be replaced as an assembly.