Drive Motor Battery Cable Terminal Extension Cover Replacement

WARNING: This page is about a different variant/trim than selected.

Fig 1: Drive Motor Battery Cable Terminal Extension Cover

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Review the high voltage safety information prior to performing the High Voltage Disabling procedure. Refer to High Voltage Safety . Disable the high voltage system. Refer to High Voltage Disabling . Tip both rear seats forward. Remove the front battery trim panel push-pins and panel. Remove the batter cross brace. Disconnect the service disconnect. Refer to Hybrid Battery Service Disconnect/Connect .
1	Terminal Extension Cover Fasteners CAUTION: Refer to Fastener Caution . Tighten: 11 N.m (98 lb in)
2	Drive Motor Battery Terminal Extension Cover Procedure: Enable the high voltage system. Refer to High Voltage Enabling .

Callout

Component Name

Preliminary Procedure

Review the high voltage safety information prior to performing the High Voltage Disabling procedure. Refer to High Voltage Safety .
Disable the high voltage system. Refer to High Voltage Disabling .
Tip both rear seats forward.
Remove the front battery trim panel push-pins and panel.
Remove the batter cross brace.
Disconnect the service disconnect. Refer to Hybrid Battery Service Disconnect/Connect .

Terminal Extension Cover Fasteners

CAUTION: Refer to Fastener Caution .

Tighten: 11 N.m (98 lb in)

Drive Motor Battery Terminal Extension Cover
Procedure:
Enable the high voltage system. Refer to High Voltage Enabling .