Flex Plate: Service and Repair

Automatic Transmission Flex Plate Replacement

Special Tools

KM-652 Flywheel Holding Tool

Removal Procedure




1. Remove the automatic transmission.
2. Detach the drive disc.

* Lock the drive disc via starter ring gear with KM-652 (1).
* Remove the 6 bolts.

Installation Procedure

Caution: Refer to Fastener Caution (Fastener Caution).

1. Attach the drive disc.

* Clean thread in crankshaft.
* Use new bolts.

Tighten the 6 bolts to 60 Nm (44 lb ft).

* Remove KM-652 .

2. Install the automatic transmission.