LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Red Line, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Input Speed Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Input Speed Sensor & Bolt
    GM812729Courtesy of GENERAL MOTORS CORP.
  1. Install the input speed sensor (1).
    2. NOTE: Refer to Fastener Notice .
  2. Install the input speed sensor bolt (2).

    Tighten:  Tighten the input speed sensor bolt to 11 N.m (97 lb in).

    3. Fig 2: View Of Input Speed Sensor & Electrical Wiring Harness Connector
    GM795916Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical wiring harness connector (1) to the input speed sensor (2).
  4. Install the transmission fluid pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
scientia non olet · About LEMON Manuals