Installation Procedure

Fig 1: Measuring Dimension X

Courtesy of GENERAL MOTORS CORP.

Measure the distance from the bottom of the gage bar to the top of the direct and reverse clutch assembly. Record this as dimension X. Refer to the Reverse Clutch Housing Selective Thrust Washer Specifications to determine the correct size to use.

Fig 2: Locating Torque Converter Fluid Seal & Clutch Housing Thrust Washer

Courtesy of GENERAL MOTORS CORP.

Use J 36850 to install the NEW torque converter fluid seal (4) onto the torque converter housing.
Use J 36850 to install the reverse clutch housing thrust washer (5).

Fig 3: View Of Fluid Pump Cover Gasket, Torque Converter Housing & Bolts

Courtesy of GENERAL MOTORS CORP.

Fig 4: Identifying Torque Converter Housing Bolts Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the torque converter housing bolts in sequence.
Tighten: Tighten the housing bolts to 22 N.m (16 lb ft).