LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Red Line, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Input & Reaction Carrier Assemble >> Assembly Procedure

Assembly Procedure

    Fig 1: Identifying Inspection Areas Of Input & Reaction Carrier
    GM801841Courtesy of GENERAL MOTORS CORP.
  1. Inspect the reaction internal gear and the 2nd clutch sprag for the following:
    • Damaged or worn gear teeth
    • Damaged or worn splines
  2. Inspect the input and reaction carrier for the following:
    • Damaged or worn teeth
    • Damaged or worn splines
    • Worn or nicked bushings
    • Worn or damaged bearings
    3. Fig 2: Installing Reaction Internal Gear Flange Washer
    GM801842Courtesy of GENERAL MOTORS CORP.
  3. Using J 36850  install the reaction internal gear flange washer (551).
    4. Fig 3: Checking 2nd Clutch Sprag Rotation
    GM801843Courtesy of GENERAL MOTORS CORP.
  4. Check that the 2nd clutch sprag rotation freewheels and locks up in the correct direction.
    5. Fig 4: Locating 2nd Clutch Components
    GM801844Courtesy of GENERAL MOTORS CORP.
  5. Install the 2nd clutch sprag (549) onto the input and reaction carrier (553).
  6. Install the 2nd clutch roller inner race bearing assembly (542) onto the input and reaction carrier (553).
  7. Install the input and reaction bearing assembly (541) onto the input and reaction carrier (553).
  8. Install the input and reaction carrier outer ring (540) onto the input and reaction carrier (553).
    9. Fig 5: View Of Input & Reaction Carrier & Thrust Bearing
    GM801817Courtesy of GENERAL MOTORS CORP.
  9. Install the input and reaction carrier thrust bearing (20) into the case.
  10. Install the input and reaction carrier (19) into the case.
scientia non olet · About LEMON Manuals