Circuit/System Testing
IMPORTANT:
Before performing this diagnostics, make sure no indicator(s) are illuminated after the IPC performs a lamp test. If any indicators are illuminated after the bulb test, perform the indicator diagnostics before this diagnostics.
Chime Inoperative
- Ignition ON, headlamp switch OFF, verify the scan tool Headlamp Switch parameter is Inactive.
- If not Inactive, refer to Headlamps Malfunction .
- Ignition ON, park lamp switch OFF, verify the scan tool Park Lamps Switch parameter is Inactive.
- If not Inactive refer to Park, License, and/or Tail Lamps Malfunction
- Ignition ON, driver door closed, verify the scan tool Door Ajar parameter is Door Closed.
- If not On, refer to Courtesy Lamps Malfunction .
- Ignition OFF, key out of the ignition, verify the scan tool Key In Ignition Status parameter is Inactive.
- If not Inactive, test the key in ignition switch signal circuit for a short to ground. If the circuits tests normal, replace the ignition switch.
Chime Inoperative
- Ignition ON, radio ON, adjust the radio balance and fade to the left front speaker.
- If the speaker does not operate properly, refer to Speaker Malfunction .
- Ignition ON, verify that the scan tool Key In Ignition Status parameter is Key In.
- If not Key In, test the signal circuit and ground for a short to voltage or an open/high resistance. If all circuits test normal, replace the ignition switch.