Circuit/System Testing

Body Control Module Voltage Out Of Range

1. Ignition OFF, disconnect the harness connector X3 at the body control module.
2. Ignition ON, verify that a test lamp illuminates between the terminal D1 and ground.
   • If the test lamp does not illuminate, repair the battery voltage circuit for an open/high resistance.
3. Ignition OFF, disconnect the harness connectors X1 and X4 at the body control module.
4. Ignition OFF, test for greater than 1.0 ohm of resistance between the following terminals and ground.
   • X1 terminal 61
   • X4 terminal E12
   • If less than 1.0 ohm, test the appropriate ground circuit for an open/high resistance.
5. If all circuits test normal, test or replace the BCM.

Engine Control Module Voltage Out Of Range

1. Ignition OFF, disconnect the harness connector X1 and X2 at the engine control module.
2. Ignition ON, verify that a test lamp illuminates between the following terminal and ground.
   • X2 terminal 56 (LNF)
   • X1 terminal 20 (LE5)
   • If the test lamp does not illuminate, repair the appropriate battery voltage circuit for an open/high resistance.
3. Ignition OFF, test for greater than 1.0 ohm of resistance between the following terminals and ground.
   • X2 terminal 1 (LNF)
   • X2 terminal 2 (LNF)
   • X2 terminal 4 (LNF)
   • X2 terminal 73 (LE5)
   • If less than 1.0 ohm, test the appropriate ground circuit for an open/high resistance.
4. If all circuits test normal, test or replace the ECM.

Instrument Panel Cluster Voltage Out Of Range

1. Ignition OFF, disconnect the harness connector at the instrument panel cluster.
2. Ignition ON, verify that a test lamp illuminates between terminal 13 and ground.
   • If the test lamp does not illuminate, repair the battery voltage circuit for an open/high resistance.
3. Ignition OFF, test for greater than 1.0 ohm of resistance between terminal 15 and ground.
   • If less than 1.0 ohm, test the ground circuit for an open/high resistance.
4. If all circuits test normal, test or replace the IPC.