LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Base, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection & Connection >> Removal Procedure

Removal Procedure

    Fig 1: Locating Transmission Oil Cooler (TOC) Quick Connect Fitting
    GM1509806Courtesy of GENERAL MOTORS CORP.
  1. Locate the transmission oil cooler (TOC) quick connect fitting (1).
    2. IMPORTANT: Be sure that the lock tang on the release tool is properly engaged.
    Fig 2: Installing The J 44827 Onto The Transmission Oil Cooler (TOC) Pipe
    GM1509804Courtesy of GENERAL MOTORS CORP.
  2. Install the J 44827  onto the TOC pipe.
    3. Fig 3: Sliding The J 44827 Toward The Transmission Oil Cooler (TOC) Quick Connect Fitting
    GM1509805Courtesy of GENERAL MOTORS CORP.
  3. Slide the J 44827  toward the TOC quick connect fitting.
    4. Fig 4: Identifying J 44827 & TOC Quick Connect Fitting.
    GM1509807Courtesy of GENERAL MOTORS CORP.
  4. Insert the J 44827  into the TOC quick connect fitting. The distance between the quick connect fitting and J 44827  should be approximately 2.00 mm (0.080 in).
    5. Fig 5: Pulling Back On TOC Pipe To Disengage Pipe From TOC Quick Connect Fitting
    GM1509808Courtesy of GENERAL MOTORS CORP.
  5. Pull back on the TOC pipe to disengage the pipe from the TOC quick connect fitting.
  6. Remove the J 44827  from the TOC pipe.
scientia non olet · About LEMON Manuals