LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Base, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Torque Converter Fluid Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Torque Converter Seal, Bolts & J 8092
    GM812733Courtesy of GENERAL MOTORS CORP.
  1. Assemble J 8092  onto J 44766  . See Special Tools .
  2. Install the torque converter seal onto the tool before installing into the case to prevent damage to the seal.
    3. IMPORTANT: Align the torque converter seal with the bolt holes.
  3. Install the torque converter seal into the torque converter housing.
    4. NOTE: Refer to Fastener Notice .
  4. Install the torque converter seal bolts.

    Tighten:  Tighten the NEW torque converter seal bolts to 3.6 N.m (32 lb in).

  5. Install the transmission torque converter. Refer to Torque Converter Replacement .
scientia non olet · About LEMON Manuals