LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2008 >> Sky Base, Automatic >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 5L40-E/5L50-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - Off Vehicle >> Case Components Assemble

Case Components Assemble

    Fig 1: Identifying Pressure Test Hole Plug & Transmission Fluid Level Hole Plug
    GM856325Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If the pressure test plug (40), O-ring (66), level hole plug (36) and O-ring (37) are not damaged, they should be reused.
  1. Inspect the pressure test hole plug (40) and O-ring (66) for damage.
    2. NOTE: Refer to Fastener Notice .
  2. Install the pressure test plug (40) and O-ring (66).

    Tighten:  Tighten the pressure test plug to 11N.m (8 lb ft).

  3. Inspect the level hole plug (36) and O-ring (37) for damage.
  4. Install the transmission fluid level hole plug O-ring (37) and the transmission level hole plug (36).

    Tighten:  Tighten the level hole plug to 20N.m (15 lb ft).

scientia non olet · About LEMON Manuals