Steering Wheel Replacement (good cell)

Fig 1: Steering Wheel

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
1	Steering Wheel Nut NOTE: Refer to Fastener Notice . Tighten: 37 N.m (27 lb ft)
2	Steering Wheel Assembly Procedure Disconnect the electrical connector. Remove the steering wheel using the J 1859-A Steering Wheel Puller with J 36541-A Steering Wheel Puller Legs. Make an alignment mark to note the relationship between the steering wheel and the steering shaft. The marks will be needed to align the wheel during installation.

Callout

Component Name

Preliminary Procedure:
Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .

Steering Wheel Nut

NOTE: Refer to Fastener Notice .

Tighten: 37 N.m (27 lb ft)

Steering Wheel Assembly

Procedure

Disconnect the electrical connector.
Remove the steering wheel using the J 1859-A Steering Wheel Puller with J 36541-A Steering Wheel Puller Legs.
Make an alignment mark to note the relationship between the steering wheel and the steering shaft. The marks will be needed to align the wheel during installation.