Digital Radio Antenna Cable Replacement

Digital Radio Antenna Cable Replacement

Removal Procedure




1. Remove the headliner.
2. Disconnect the antenna cable from the antenna base cable connector.
3. Remove the retainer clips from the antenna cable.




4. Open the right side end cap from the instrument panel (I/P) to disconnect the cable connectors.




5. Disconnect the antenna cable from the digital radio receiver.
6. Remove the antenna cable retainers from the receiver bracket.
7. Remove the antenna cable.

Installation Procedure




1. Install the antenna cable retainers to the receiver bracket.




2. Connect the antenna cable to the digital radio receiver.




3. Install the cable connectors to the right side end cap on the I/P.




4. Install the antenna cable retainer clips.
5. Connect the antenna cable to the antenna base cable connector.
6. Install the headliner.