Charge Indicator Inoperative
Charge Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Connector End View Reference: Engine Electrical Connector End Views , Engine Control Module (ECM) Connector End Views in Engine Controls - 2.2L (L61), or Powertrain Control Module (PCM) Connector End Views in Engine Controls - 3.5L (L66) | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Turn ON the ignition, with the engine OFF. Does the battery charge indicator illuminate? |
Go to Step 4 | Go to Step 3 |
| 3 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 7 |
| 4 | Test the generator turn on signal circuit for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 8 | Go to Step 5 |
| 5 | Inspect for poor connections at the harness connector of the engine control module (ECM)/powertrain control module (PCM). Refer to Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 8 | Go to Step 6 |
| 6 |
IMPORTANT:
The replacement ECM/PCM must be programmed. Replace the ECM/PCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming.Did you complete the replacement? |
Go to Step 8 | - |
| 7 | Replace the instrument panel cluster. Refer to Control Module References
in Computer/Integrating System for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |