Installation Procedure

Fig 1: Identifying Cylinder Plug Locking Tab

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: If this is the initial installation of the I/P compartment door lock, you must first remove the factory installed cylinder plug by depressing the locking tab and pushing the plug out of the door.

IMPORTANT: When you insert the key into a properly coded lock cylinder, all of the tumblers except the retainer cylinder will be flush with the lock cylinder.

Insert the key into the lock cylinder.

Fig 2: Removing & Installing Lock Cylinder

Courtesy of GENERAL MOTORS CORP.

Place the key and the lock cylinder into the I/P compartment door handle.
Rotate the lock cylinder counterclockwise 180 degrees to engage the retainer tumblers.

Fig 3: View Of Instrumental Panel (I/P) Compartment Door

Courtesy of GENERAL MOTORS CORP.

Install the cover on the I/P compartment door.